Tips - V23 Obsolete Toolpaths

Q. Can I use older toolpaths in V23?

A. The older toolpaths are obsolete, with the exception of Z-level Finishing (V18) and Parallel Roughing.

Here is a list of the obsolete toolpaths. These will no longer be available from the menu. If these toolpaths are calculated in an old workzone they can be edited and post processed. The parameters of the toolpath can be reviewed, but no calculation/re-calculation can be performed.

  • High Feed Roughing
  • Hard Material Roughing
  • High Torque Roughing
  • Old Flat Surface Roughing (A new version has been available since V22)
  • Contour Roughing-Block
  • Contour Re-Roughing
  • Contour Re-Roughing
  • Old Flat Surface Finishing (A new version has been available since V22)
  • Old Tangent to Curve (A new version has been available since V22)
  • Old Pocketing (A new version has been available since V22)
  • Old Curve Remachining (A new version has been available since V22)
  • Old On-curve-Engraving-(A new version has been available since V22)
  • Old Facing (A new version has been available since V22)
  • 5-Axis-Rolling
  • 5-Axis-Rolling Between Curves
  • 5-Axis-Profile
  • 5-Axis-Grooves
  • 5-Axis-Pocketing
  • 5-Axis-Planar-Finishing
  • 5-Axis-Parallel to Curve
  • 5-Axis-Perpendicular to Surface
  • 5-Axis-3D Finishing
  • 5-Axis-Normal to Surface
  • 5-Axis-Z-level Finishing (Blade)
  • 4-axis-Z-Level Finishing
  • 5-axis Blades (V18)

View all tips